Korg EasyStart microX Manual de usuario descargar pdf (Pagina 12)

Setup

Setting up the microX/X50 Plug-In Editor

If you want to use the microX/X50 Plug-In Editor with the microX/X50 connected to

your computer via USB, you must make sure that you have ﬁnished installing and

setting-up the KORG USB-MIDI Driver before you start up the microX/X50 Editor.

This section explains how to set up the microX/X50 Plug-In Editor in your host application

and make settings so that it will operate correctly. Make settings as appropriate for your sys-

tem and setup.

About the microX/X50 Plug-In Editor

The microX/X50 Plug-In Editor sends and receives only parameter data to and from the

microX/X50. Unlike typical plug-in instruments, the microX/X50 Plug-In Editor does not

produce an audio signal. Your microX/X50 will output audio signals when the microX/X50

Plug-In Editor sends it MIDI messages.

If you want to send the microX/X50’s audio signal to an audio track of your host application

and use it in conjunction with a plug-in effect etc., refer to “Using your host application to

control the microX/X50’s audio signal” (☞p.10).

Note: Because the microX/X50 Plug-In Editor does not handle audio signals, you can’t insert a

plug-in effect into the channel of the track in which the microX/X50 Plug-In Editor is

inserted, or send its audio signal via a send or bus.

to Mixer to DAW's

Audio Track

(DAW's Audio In)

Instrument On Track

DAW

MIDIAUDIO

Mac / PC

AUDIO OUTPUTS

Note:

Does not

produce an

audio signal.

TONE

GENERATOR

USB

AUDIO INTERFACE

AUDIO I/O

INPUTS

Plug-In Editor

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 32 33

Sin comentarios

Korg EasyStart microX Manual de usuario Pagina 12